Control Box Repair & Replacement

Well Pump Control Box Repair for Brooksville Homes


Many submersible well pumps rely on a control box mounted above ground. Inside are the capacitors and relay that give the pump motor the boost it needs to start, then keep it running and protected. Heat, age, power surges and lightning can all wear these parts out.



When the control box fails, the pump below can’t start even if it’s in perfectly good shape. That’s why Access Pump & Well Repair tests the control box before recommending a new pump. Finding a failed capacitor or relay can save you from replacing a pump you don’t need to replace.

Black warning triangle with a white exclamation mark inside.

Signs Your Well Pump Control Box Is Failing

Pump Hums but Won’t Start

A humming sound with no water usually means the motor isn’t getting the starting boost it needs.

Breaker Keeps Tripping

Repeated trips can point to a shorted capacitor or failing relay inside the control box.

No Water After a Storm

Lightning and power surges are common causes of sudden control box failure.

Clicking From the Box

A relay that clicks without starting the pump may be worn or stuck.

Burn Marks or a Burning Smell

Scorching, melted wiring or a burnt odor near the box means it needs attention right away.

Deciding Between Control Box Repair & Replacement


If a single part has failed, like a start capacitor or relay, replacing that component is often all your control box needs. It’s a targeted repair that gets your pump running again without replacing the whole unit.



If the box shows burn damage, corrosion or heavy wear, or it was hit by a power surge, a full replacement is usually the safer choice. Either way, the control box has to match your pump motor, so we make sure every part we install is the right fit for your system.

Well Pump Control Box Questions


  • What does a well pump control box do?

    The control box holds the capacitors and relay that start your submersible pump motor and help protect it while it runs.

  • Can a bad control box make it seem like the well pump failed?

    Yes. A failed control box can stop a healthy pump from starting, which is why we test the box before recommending a new pump.

  • Does every well pump have a control box?

    No. Three-wire submersible pumps use a separate control box, while two-wire pumps have the starting components built into the motor.

  • Is emergency control box repair available?

    Calls are answered 24/7. Depending on the situation, nighttime calls may be scheduled for daylight service.

Get Your Control Box Fixed Today

If your pump is humming, tripping the breaker or won’t start after a storm, call Access Pump & Well Repair. We’ll test the control box and get your water running again.